GE JV655 Secure Hood, Connect Wiring, Connect Ductwork To Hood, Install Light Bulbs

Installation Instructions

[] SECURE HOOD

Slide the hood back against the wall. Tighten

the mounting screws. Be sure the screw heads are in the narrow neck of the keyhole slot.

[] CONNECT WIRING

Connect house black to hood black wire, house

white to hood white wire, and house grotmd trader

green ground screw. Securely tighten the strain relief clamp onto the house wiring.

ir0und screw

(4)

Keyhole(4)

NOTE: DO NOT PUSH ON E__N BI,ADE. Pushiw,

on the blade ma_ cause it to interiere with other

hood parts.

[] CONNECT DUCTWORK TO

HOOD

Use duct tape to make joints secm'e and air tight.

Ducttape

[] INSTALL LIGHT BULBS

Pro'chase and install two PAR20, 50 _\ maximum

halogen bulbs.

[] REPLACE WIRING COVER

On models so equipped, replace the wiring coxer or the bottolU coxer.

[] REPLACE FILTERS

Make sm'e tan blade turns freel). The installation is complete. Turn on power at set\ice panel, and test

fi)r proper operation.

[] FOLLOW ELECTRICAL CODE

Complete the electrical wiring according to

National Electrical Code and local codes.

NOTE: This hood must be pemmnently grotmded.

Connect house wMng (120 VAC) to hood wiring.

TROUBLESHOOTING CHECKLIST

]f the hood seems to be operating at high speed when the control is not set on high, or if ventilation seems

inadequate, check the ti_llowing:

U_JKnockouts not removed from hood.

Damper blade not opening.

Reduced airflow because the duct is too small or the duct length is too long.

The duct is blocked.

U_JUndersized or restrictive wall or roof cap.

14