Installation
[] REMOVE DUCT KNOCKOUT(S)
If recirctdath_g,
Step 12 D and proceed. We do not recommend the
recirculated configuration for JV6 Series models.
Using a fiat blade screwdriver; remove the ai_i_ropriate
duct lmockout(s) fi'om the top or back of the hood.
3'/4"xI0" Rectangular | 7" Roundvertical |
vertical discharge• | discharge, Removesemi- |
Removetop rectangular | circularduct knockoutandtop |
ductknockoutonly. | rectangularductknockout. |
3'/4"x 10" Rectangular
horizontal discharge• Remove
rear rectangular duct knockout only.
NOTE: If the hood is to be installed in a recirculating,
kit nmnber WB02X10707 fin" 30" hood models or
kit ntlillbeF WB02X10708 fin" 36" hood models.
These kits can be ordered ti'om yore" GE sui_plie_: Skip to Step 12 D mid proceed.
[] FOR HORIZONTAL DISCHARGE
INSTALLATIONS ONLY:
Remove the plate (on models so equiI)ped ) in fl'ont
of the horizontal discharge knockout. Cut the ties, lift plate out and discard plate. DO NOT REMOVE the metaJ strip held in place with two screws.
Metal strip Ties
Screw
Instructions
[] FOR 31/4" X 10" RECTANGULAR
DUCTED DISCHARGE INSTALLATIONS ONLY:
Mtach exhaust | adaptor/da_aper | over | knockout | ||
opening with | two exhaust | adaptor | screws. | Make sure | |
damper pivot | is nearest | to top/back | edge | of hood. | |
Remove tape ti'om damper flap. |
|
|
| ||
Upto 1" |
|
|
|
| Tape |
sideadjustment |
|
|
|
|
|
Pivot
Exhaustadaptor/damper
(verticaldischargeposition
shown)
NOTE: The exhaust | adai)tor/damper | can be installed |
up to 1 inch on either side of the hood center to
aCCOlillilo(late off=center ductwork. ]n extreme off =
center installations, one end of the duct connector may
need to be trimmed to clear the electrical cable clamp.
[] FOR 7" ROUND VERTICAL
DUCTED DISCHARGE INSTALLATIONS ONLY:
screws, removed in Step 2 trader the "Prepare the Hood" section.
NOTE: The 7" rotmd exhaust adaptor can be installed up to 1 inch on either side of the hood center to
aCCOllllllodate | oItcenter | dtlctwork. | In exti'ellle | oItLcenter |
instnllations, one end of the duct connector may need to be trimmed to clear the electrical cable clamp.
NOTE: The 7" r(mnd damper is not included with this i_roduct. It can be i_m'chased as a kit b) calling
800.626.2002. Order kit nmnber,]'X[ A2..
12
