OPERATING | 5. | Press in control knob and turn counterclockwise | |
| Keep control knob pressed in for five (5) seconds (see Figure 23). | ||
HEATER |
| ||
| Note: You may be running this heater for the first time after hooking up to gas | ||
|
| supply. If so, the control knob may need to be pressed in for 30 seconds. This will | |
| allow air to bleed from the gas system. |
| |
Models |
|
| |
| • If control knob does not pop out when released, contact a qualified service | ||
Continued |
| ||
| person or gas supplier for repairs. |
| |
| 6. With control knob pressed in, press and release ignitor button. This will light pilot. | ||
|
| The pilot is attached to the front burner. If needed, keep pressing ignitor button | |
|
| until pilot lights. |
|
|
| Note: If pilot does not light, contact a qualified service person or gas supplier for | |
|
| repairs. Until repairs are made, light pilot with match. To light pilot with match, | |
|
| see Manual Lighting Procedure, below. |
|
| 7. Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, | ||
|
| release control knob. |
|
|
| Note: If pilot goes out, repeat steps 3 through 7. | Ignitor Electrode |
|
|
| |
|
| Thermocouple | Pilot Burner |
|
|
| |
Figure 24 - Pilot
8. Turn control knob counterclockwise 
to the LOW position. The front burner should light. Set control knob to either HIGH, MEDIUM, or LOW. To turn control knob from LOW to a higher setting, press in the control knob and turn
counterclockwise 
. On LOW and MEDIUM positions, only front burner operates. On HIGH position, front and rear burner operates.
WARNING
WARNING ICON | G 001 |
HIGH, MEDIUM, and LOW are locked positions. You must press in control knob before turning it from these positions. Do not operate heater between locked positions or sooting could occur.
CAUTION
WARNING ICON | G 001 |
Do not try to adjust heating levels by using the manual shutoff valve.
TO TURN OFF GAS TO APPLIANCE
Shutting Off Heater |
|
| |
1. | Press in and turn control knob clockwise | Clockwise | to the PILOT position. |
2. | Press in control knob and turn clockwise | Clockwise | to the OFF position. |
Shutting Off Burners Only (pilot stays lit)
1. Press in and turn control knob clockwise Clockwise
to the PILOT position.
MANUAL LIGHTING PROCEDURE
1.Follow steps 1 through 5 under Lighting Instructions, page 22.
2.Depress control knob and light pilot with match.
3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30
seconds, release control knob. Now follow step 8, above. | 23 |
101309
