INSTALLATION

Optional Wireless Hand-Held Remote Control Accessories Installing 9-Volt Batteries

15

INSTALLATION

Continued

OPTIONAL WIRELESS HAND-HELD REMOTE CONTROL ACCESSORIES (GHRCB and GHRCTB)

Installing Remote Receiver Unit

1.Disconnect switch wires from the control valve.

2.Remove screws attaching switch plate.

3.Remove switch plate (see Figure 26). Discard after removing.

4.Install remote receiver unit onto gas log heater base using mounting clips.

5.Push clips firmly into place (see Figure 27).

6.Connect wires as shown in Figure 28.

Remote Switch

Ignitor

Bracket

 

Screw

 

Wires

Switch

Plate

Figure 26 - Switch Plate and Wiring Harness

Mounting

Clips

Installing 9-Volt Battery (Not Included) in Receiver

1.Locate back of receiver under front burner of heater.

2.Locate the battery clip mounted on the back of the receiver.

3.Slide a 9-volt battery through the clip.

4.Attach the terminal wires to the battery.

Remote

Receiver

9-Volt

Battery Terminal Battery Clip Wires

Figure 29 - Installing Battery in Remote Receiver

Installing 9-Volt Battery (Not Included) in Hand- Held Remote Control Unit

1.Remove battery cover on back of remote control unit.

2.Attach terminal wires to the battery. Place battery into the bat- tery housing.

3.Replace battery cover onto remote control unit.

Remote Receiver

Figure 27 - Installing Remote Receiver

Battery

Cover

Terminal Wires

9-Volt Battery

Remote

Control Unit

Battery

Housing

White Wire

 

From

Valve

Receiver

 

Red Wire

From

Receiver

Figure 28 - Connecting Wires

INSTALLING 9-VOLT BATTERIES

Two 9-volt batteries (not included) are required to operate this heater with the wireless hand-held remote control set. Install one battery in the receiver and one in the hand-held remote control unit. Note: Only use alkaline batteries.

Figure 30 - Installing Battery in Hand-Held Remote Control Unit (GHRCB Series)

9-Volt

Terminal

Wires

Battery

 

Remote

Control

Unit

Battery

Cover

Figure 31 - Installing Battery in Hand-Held Remote Control Unit (GHRCTB Series)

For morevisit www..com

111285-01B

Page 15
Image 15
Desa VI33NR VI33PR installation manual Installing 9-VOLT Batteries, Installing 9-Volt Battery Not Included in Receiver