Desa VM42P Opening Vent Damper, Spring, Clip Screw Side Front, Partially Opened Door

INSTALLATION

Continued

6.	Repeat the process for the opposite door
	assembly.
7.	To adjust the doors, slide them partially open.
	Using a screwdriver, loosen the hold-down
	screws in the spring clip (see Figure 36) and
	pivot plate.
8.	Close both doors until evenly joined at the
	middle and note the gap at the outer edges of
	the face.
9.	Reopen one door at a time and retighten the
	upper and lower hold-down screws.
10.	Repeat the process until both doors are evenly
	joined, spaced and working freely.

Fold Bi-Fold

Door After

Releasing

Spring Clip

and Slide

Door Out of

Upper Track

Spring Clip

Depress Spring Clip to Release Pivot Pin

CAUTION: The glass pan- els become very hot while the appliance is operating. Do not attempt to adjust or clean the glass doors until the appliance has fully cooled.

The doors may be removed for replacement or cleaning as follows:

1.Partially open the door and press up on the upper spring clip with a screw driver until the outer top pivot pin is free of the clip.

2.Fully fold the frame assembly and slide the upper edge towards the center of the firebox opening until the guide pins are free of the frame rail (see Figure 37).

CAUTION: Always operate the appliance with the doors ei- ther fully opened or fully closed. Operating the appliance with the doors partially open can re- sult in improper venting of flue products.

Spring	Hold-Down
Clip	Screw
Side
Front
Face
Partially
Opened
Door

Figure 36 - Adjusting Glass Doors

Remove Bottom Pin
From Pivot Plate While	Pivot Plate
Sliding Door Out of the
Upper Track
Figure 37 - Removing Glass Doors

OPENING VENT DAMPER

Vent damper must be locked in the full open posi- tion before operating the fireplace. If vent damper is not open, fireplace will not light.

	VENT DAMPER MUST BE LOCKED
	IN THE FULL OPEN POSITION
OPEN	TO OPERATE THE APPLIANCE	CLOSE

Figure 38 - Opening Vent Damper

18 www.desatech.com 108795-01N