Desa VM42P Inspecting Burners, To Turn OFF GAS To Appliance, Optional HAND-HELD Remote Operation

OPERATING FIREPLACE

Continued

TO TURN OFF GAS

TO APPLIANCE

1.Turn off the wall switch.

2.Turn off all electric power to the appliance if service is to be performed.

3.Fully open glass doors if installed.

4.Remove front hearth brick and control access panel.

5.Turn gas control knob clockwise to “OFF”. Do not force.

6.Replace front refractory brick access panel.

7.Fully close glass doors if installed.

Pilot

Burner

Thermopile

Ignitor

Figure 40 - Pilot

OPTIONAL HAND-HELD

REMOTE OPERATION

Note: The receiver and hand-held remote control kit must be purchased separately (see Accessories, page 31). Follow installation in- structions on page 10 of this manual.

1.After lighting, let pilot flame burn for about one minute. Turn control knob to ON position. Slide the selector switch to the REMOTE position. Note: The burner may light if hand-held remote was on when selector switch was last turned off. You can now turn the burner on and off with the hand-held remote control unit.

IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

2.Press the control button on the hand-held remote to turn the burner on. Press the control button again to turn burner off (see Figure 41).

3.To Lock press both buttons on remote control until light stops flashing. Remote is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed.

4.To Unlock press both buttons together on remote control until light stops flashing. The remote is now unlocked.

Indicator

Light

Control

Button

Figure 41 - On/Off Hand-Held Remote Control Unit HRC100

INSPECTING BURNERS

Check pilot flame pattern and burner flame pat- terns often.

PILOT ASSEMBLY

The pilot assembly is factory preset for the proper flame height. Alterations may have occurred dur- ing shipping and handling. The pilot is located on the back right hand side of the burner.

The height of the thermopile must be 3/8" to 1/2" above the pilot flame. The flame from the pilot burner must extend beyond the thermopile.

If your pilot assembly does not meet these re- quirements:

•Turn the adjustment screw marked pilot clockwise to decrease or counterclockwise to increase the flame to proper size (see Figure 39, page 19). Do not remove the adjustment screw.

•see Troubleshooting, page 19

20 www.desatech.com 108795-01N