® VMH26PR
COMPACT CLASSIC HEARTH FIREPLACE
ASSEMBLY
WARNING: Always have branch support and screen in place before operating fireplace. This prevents excessive tempera-
Back Log | Screen | |
Shipping | ||
| ||
| Screw |
Shoulder Screw
tures on fireplace surfaces.
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this fireplace may result in prop- erty damage or personal injury
ASSEMBLING FIREPLACE
Tools Required:
•Phillips screwdriver
•5/16" hex wrench
•slotted screwdriver
Installing Log
Screw
Screw
Screen
Branch
Figure 2 - Assembling Fireplace
Burner Support
Branch Support
1.Remove back log, branch, and hood from log box. Discard protective packaging.
2.Remove two shipping screws above screen (see Figure 2).
3. Lift screen up and pull out to remove.
4. An optional blower is available. See Ac- cessories, pages 26 and 27. Install op- tional blower now. Follow installation instructions provided with blower.
5. Gently place back log on burner sup- port (see Figure 2). The log should fit flat against top of burner support. Place two #10
6. Place branch on branch support (see
Figure 2). Do not allow branch to con-
tact flame. If flame contacts branch, Figure 3 - Assembling Hood soot will be created.
7.Reattach screen by placing the notches in the screen frame over the shoulder screws and pushing down.
Assembling Hood
1.Locate four
2.Slip top of hood between middle rail and top of firebox wrapper (see Figure 3).
3.Attach four
Upper Louver
AssemblyMiddle
Rail
Firebox
Wrapper
Hood
4 | 104323 |