® VMH26PR
COMPACT CLASSIC HEARTH FIREPLACE
INSTALLATION
Continued
9.Install the switch plate on the valve cover shield with 2 #10 screws provided (see Figure 17). Route power cord out of the cabinet by inserting it through the bushing on the outer casing (see Figure 16, page 11). Plug fan kit into
Valve
Cover
For Built-In Installation
WARNING: A licensed electri- cian must connect the wiring har- ness to electrical supply follow- ing all local codes. Electrician must provide a clamp on the box cover to secure the wiring. Wir- ing should be routed through the bushing in the hole on the outer casing of heater.
1.Install a snap bushing found in hard- ware kit into one of the holes found rear of valve cover shield. The other hole is for a strain relief clamp (not supplied) to secure incoming electrical supply.
2.Follow steps 2 through 6 in Installing Blower Assembly, page 11.
3.A licensed electrician must follow the wiring diagram to connect incoming electrical supply to fan kit wiring harness (see Figure 20).
4.Plug power cord to the outlet receptacle (not provided) as shown in figure 19. Wind the extra cable in power cord and and tie it up with the plastic wire strap (see Figure 19). Set the cable bundle between the burner bracket and outer casing, away from the burner.
5.Test to make sure the blower is work- ing properly.
6.Reinstall upper louver assembly (see Fig- ure 15, page 11) and close lower louver.
| Fan Switch |
|
|
|
|
|
| ||||
| (Auto/Off/On) |
|
|
|
|
|
| ||||
|
| 1 Auto |
|
|
|
|
|
| |||
| Off | 2 |
|
|
|
|
|
|
|
|
|
|
| 3 | Blue |
| Thermostat | ||||||
|
|
| On |
|
|
| Switch | ||||
|
|
|
|
|
| (N.O.) | |||||
110/115 |
|
| Red |
|
|
|
| Blue | |||
V.A.C. |
|
|
|
| Blower | ||||||
| Black |
|
|
|
|
|
|
|
| Motor | |
|
|
|
|
|
|
| Red |
| |||
| White |
|
|
|
|
|
| White |
| ||
| Green |
|
|
|
|
|
| Green |
Figure 20 - Wiring Diagram For Blower Accessory
Shield
Screw
Switch Plate
Figure 17 - Installing Switch Plate to Valve Cover Shield
Fan Switch
(Auto/Off/On)
1Auto
| Blower Bracket |
| Assembly |
Screw | Wire |
| Harness |
Switch | Power | Outlet |
Cord | Receptacle | |
| (Not Supplied) | |
|
|
|
| Off | 2 |
|
|
| 3 |
|
|
| On |
110/115 | Red | ||
| V.A.C. |
| |
|
| Black |
|
|
|
| |
|
| White |
|
|
| Green |
|
Blue Thermostat
Switch
(N.O.)
Blue
Blower
Motor
Red
White
Green
Blue Red
Switch
Plate
Figure 18 - Wiring Diagram For Blower
Accessory Standard Installation
Plastic
Wire Wire
Harness Strap
Clamp Connector (not included)
Figure 19 - Installing Blower Bracket Assembly
12 | 104323 |