Mounting Heater To Floor, Installing Bottom Mounting Screws

INSTALLATION

Installing Heater To Wall (Cont.) Mounting Heater To Floor

INSTALLATION

Continued

Installing Bottom Mounting Screws

1.Locate two bottom mounting holes. These holes are near bot- tom on back panel of heater (see Figure 12).

2.Mark screw locations on wall.

3.Remove heater from mounting bracket.

4.If installing bottom mounting screws into hollow or solid wall, install wall anchors. Follow steps 1 through 4 under Attaching To Wall Anchor Method, page 9.

If installing bottom mounting screw into wall stud, drill holes at marked locations using 9/64" drill bit.

5.Replace heater onto mounting bracket.

6.Place spacers between bottom mounting holes and wall anchor or drilled hole.

7.Hold spacer in place with one hand. With other hand, insert mounting screw through bottom mounting hole and spacer. Place tip of screw in opening of wall anchor or drilled hole.

8.Tighten both screws until heater is firmly secured to wall. Do not over tighten.

Note: Do not replace front panel at this time. Replace front panel after making gas connections and checking for leaks (see pages 11 and 12).

MOUNTING HEATER TO FLOOR

Mounting Base Feet to Heater

1.Lay heater cabinet on its back on a table with the heater bot- tom overhanging the table edge.

2.Align holes in base foot with mounting holes on bottom of cabinet (see Figure 13).

3.Secure base foot to heater using sheet metal screws.

4.Repeat for other side.

Mounting Base Feet to Floor (Where required by local code)

1.Remove front cover (see Removing Front Panel of Heater, page 8).

2.Position heater with base feet in desired location. Mark holes for drilling. Remove heater with base.

3.For carpeted floors, make a small cut with a sharp knife at marked locations prior to drilling. If mounting base to a wood floor, drill 1/8 inch diameter hole, 3/4 inch deep. (Do not use anchors in wood floors).

If mounting base to a concrete floor, drill with 1/4 inch diam- eter concrete drill bit, 13/8 inches into floor. Insert anchors com- pletely into holes.

4.Reposition heater with base feet over holes. Secure base to floor with wood screws. See Figure 13.

Wood

Screw

Front View

Wall

Heater

Base Foot

Spacer

Sheet Metal Screw

Side View

Figure 13 - Installing Base Feet

Figure 12 - Installing Bottom Mounting Screws