OPERATING FIREPLACE
For Your Safety Read Before Lighting
Lighting Instructions
To Turn Off Gas To Appliance
Optional Remote Operation
25
OPERATING FIREPLACE
FOR YOUR SAFETY READ
BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS
NOTICE: During initial operation of new heater, burn- ing logs will give off a
1.STOP! Read the safety information, above.
2.Turn off all electric power to the appliance.
3.Turn wall switch to the OFF position.
4.Open lower louver panel.
5. Turn equipment shutoff valve clockwise Clockwise
to the OFF position (see Figure 48). Do not force.
6.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Fol- low “B” in the safety information above. If you don’t smell gas, go to the next step.
7.Turn equipment shutoff valve counterclockwise 
C-clockwise
8.Close lower louver panel.
9.Turn on all electric power to the appliance.
10.Turn the wall switch to the ON position.
11.Visually locate the pilot. The ignitor should begin to spark and the main burner should ignite once flame ap- pears at pilot.
•If lighting the appliance for the first time each season, it may take several attempts before the supply gas can reach the pilot and main burners.
•If the appliance will not stay lit after several attempts, follow the instructions To Turn Off Gas To Appliance, below, and call your service technician or gas supplier.
Equipment Shutoff Valve | Adjustment Screw |
|
Figure 48 - Turning Equipment Shutoff Valve to the OFF Position
TO TURN OFF GAS
TO APPLIANCE
1.Turn off the wall switch.
2.Turn off all electric power to the appliance if service is to be performed.
3.Open lower louver panel.
4. Turn equipment shutoff valve clockwise Clockwise
to OFF.
Do not force.
5.Close lower louver panel.
Sensing Rod
Pilot Burner
Ignitor
Figure 49 - Pilot
OPTIONAL REMOTE OPERATION
Note: The WRC receiver and
1.Turn equipment shutoff valve to ON position.You can now turn the burner on and off with the
2.Press the ON/OFF button to turn the burner on and off.
For more
visit www.
.com
108860
