INSTALLATION
Continued
Securing Hearth Base to Floor
I.Position hearth base in desired location. Mark holes for drilling (See Figure 18). Remove hearth base.
OWNER'S | MANUAL | ||
Bottom of Heater | C. MOUNTING | HEATER WITH | |
Shipping | OPTIONAL | HEARTH BASE (IF | |
Screw | |||
Base | APPLICABLE) | TO OPTIONAL | |
| MANTEL |
|
|
| See Instructions | Included With | |
| Mantel Kit. |
|
|
2, For carpeted floor, make a small cut with a sharp knife at marked loca- tions before drilling. If securing to a wood floor, drill a 3/4" deep hole
using a 1/8" diameter drill bit. Do not
use anchors in wood floors. If securing to a concrete floor, drill a 1
3/8" deep hole using a 1/4" diameter concrete drill bit. Completely insert anchors into each hole.
3.Mount heater to hearth base following steps under Mounting Heater to Op- tional Hearth Base, below. After
mounting heater, position heater and hearth base over drilled holes. With
slotted screwdriver, secure hearth base to floor with four wood screws.
Mounting Heater to Optional Hearth Base
1.Lay heater on its back on a table with the bottom of heater overhanging the edge of the table.
2.Remove 2 shipping screws in bottom of heater. Discard shipping screws.
3.Line up mounting holes on top of hearth base with holes in bottom of heater (see Figure 18).
4.Using a Phillips screwdriver, secure hearth base to heater with four sheet
metal screws (see Figure 18).
5.Stand heater up on base.
6.Place hearth insert in hearth base as shown in Figure 19,
7.Assemble brass trim (see steps 1 through 7 under Assembling and At- taching Brass Trim, page 5).
8.Slide base trim on heater base. Attach brass trim to base with two brass screws included as shown in Figure 19 below.
Holes
Holesfor Securing Sheet Metal Screw
Heater to Floor
Figure 18 - Attaching Heater to Hearth Base
Laminate
Sheet
Insert
Screw
Brass Base
Trim
Figure 19- Placing HearthInserton Heater Base and Attaching Brass Base Trim
Assembling Mantel
IMPORTANT:Only use the optional man- tels specified in this manual. See Accesso- ries, page 21 for proper mantel kits. This heater is only approved for use with models
GMFB00/GMUB01 series, GM900F/ GM901U series, GMT00F/GM701U series,
GMC22F/GMC23U/GMC24U series,
GMC32F/GMC33U series, GMC34F/ GMC35U series and GMC26F/GMC27U/
GMC28F series mantel kits. Using any other mantel will void the A.G.A. approval for this heater. Do not use models GMF800/ GMUB01 series, GM900F/GM901U series,
GM700F/GM701U series, GMC22F/
GMC23U/GMC24U series, GMC32F/ GMC33U series, GMC34F/GMC35U se- ries and GMC26F/GMC27U/GMC28F
mantels with any other product. If the metal base is required with your mantel, the heater must be mounted on the base first
Continued
lcw._ | 11 |
