This table lists the types of Ethernet cable to use for connecting directly to a computer or to an external hub or switch (if connecting more than four computers).
LAN 10/100M PORT | ETHERNET CABLE TYPE |
| |
|
|
|
|
|
| COMPUTER | HUB/SWITCH |
|
|
| |
1, 2, 3 | crossover | ||
|
|
|
|
4 | UPLINK button ”on“ (pushed in) | crossover | |
|
|
|
|
4 | UPLINK button ”off“ (out) | crossover | |
|
|
|
|
The corresponding LAN LED on the front panel lights up when the Teledat Router 400 is on and properly connected to a computer or a hub.
Power inlet 5 Volts DC/2.4A
WARNING! Only use the supplied power adapter.
Connect the round end of the power adapter to the port labeled 5VDC/2.4A on the rear panel of your Teledat Router 400.
Additional Installation Requirements
1.1. A computer with an installed Ethernet NIC (Network Interface Card).
2.2. A DSL modem and an Internet account
10
