OPERATION
BEFORE STARTING
1.Move pressure washer to level ground.
2.Check engine oil level. Refer to engine manufacturer's manual for procedure.
NOTE
The engine on this pressure washer is equipped with a low oil sensor. The amount of oil in the engine must be correct or the engine will not start.
3.Verify that filter screen is in water inlet of pump, as shown.
screen filter
4.Connect water supply hose to water inlet of pump as shown.
NOTE
The water supply must provide a minimum of 5 gallons per minute at 20 PSI.
NOTE
Use cold water only.
High
Pressure
Hose
Water
Supply
Hose
Never pull water supply hose to move pressure washer. This could damage hose and/or pump inlet.
5.Attach threaded end of high pressure hose to spray gun as shown. Tighten securely with an adjustable wrench.
6.Attach other end of high pressure hose to quick connect fitting on pump as shown.
7.Make sure high pressure hose and water supply hose are securely connected to pump.
8.If you are applying a chemical or cleaning solution see How To Siphon Chemicals/Cleaning Sol- vents in this section.
9.Turn water supply on.
Never turn water supply off while pressure washer engine is running or damage to pump will result.
10.Add fresh, unleaded regular gasoline to engine fuel tank.
NEVER FILL FUEL TANK INDOORS. NEVER FILL FUEL TANK WHEN ENGINE IS RUNNING OR HOT. DO NOT SMOKE WHEN FILLING FUEL TANK.
11 — ENG
