5.Assemble longer section of rear guide rail (P) Fig. 18, and shorter section of guide rail (R) to extension wings and saw table at points (A) with 16MM long hex head screw (S), two flat washers (T), lockwasher (V), and hex nut (W); and at points (B) and (C) Fig. 18, with 16MM long hex head screws (S), lockwasher (V) and one flat washer (T). NOTE: DO NOT COMPLETELY TIGHTEN HARDWARE AT THIS TIME. Hardware at point (C) Fig. 18, will be positioned between guide rails (P) and (R) as shown in Fig. 19.
6.Using a square (X) Fig. 19, set a depth of 7/16″ on the scale, place the square (X) at the center and on top of the saw table. Working toward the two ends of the rear guide rail, make certain the rear guide rail is parallel to the saw table, at 7/16" from the top of the table. Tighten all mounting hardware as height adjustment is made to the rear guide rails.
ASSEMBLING RIP FENCE
1.Insert handle (A) Fig. 20 into threaded hole (B) in rip fence (C).
2.Insert flat head screwdriver into rip fence handle (A) Fig. 21 and tighten screw (not shown).
Tighten hex nut (D) Fig. 21 against fence body.
P
R
A
B
C B 
T V W
S
A
Fig. 18
X
P
C
R
Fig. 19
C
B
A
Fig. 20
A
D
Fig. 21
13
