English
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.
•Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction activities. Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disperse dust, which may cause serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct particles away from face and body.
WARNING: Always wear proper personal hearing protection that conforms to ANSI S12.6 (S3.19) during use. Under some conditions and duration of use, noise from this product may
BPM | beats per minute | n | rated | |
OPM | oscillations per minute | speed | ||
RPM | revolutions per |
|
| earthing |
|
| |||
|
| |||
| minute |
|
| terminal |
sfpm | surface feet |
|
| .....................safety alert |
..................... | per minute |
|
| symbol |
SPM | strokes per minute |
|
|
|
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
Motor
Be sure your power supply agrees with the nameplate marking. Voltage decrease of more than 10% will cause loss of power and overheating. DEWALT tools are factory tested; if this tool does not operate, check power supply.
contribute to hearing loss.
•The label on your tool may include the following symbols. The symbols and their definitions are as follows:
| V | volts | A | amperes | |||||||
| Hz | hertz | W | watts | |||||||
| min | minutes |
|
| or AC | alternating | |||||
|
|
|
|
|
| or DC | direct current |
|
|
| current |
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| Class I Construction |
|
| or AC/DC | alternating |
|
|
|
|
| ................. |
|
| ||||
| ..................... |
|
|
|
| (grounded) | ........................ |
| or direct | ||
|
|
|
|
| ................. | Class II Construction | no |
| current | ||
|
|
|
|
|
|
| (double insulated) | .................... | no load | ||
…/min | per minute |
|
|
| speed | ||||||
4
FIG. 1
B
E
A
C
F
G
D
