DeWalt DWE315K instruction manual Operation, Lock-on Button Fig, Cut Guide, English

FIG. 8 FIG. 9

F

G N

CUT GUIDE

This feature allows you to more accurately track a marked cut line.

1.Insert the guide arm (G) as shown in Figure 10 into the slots on the left and right sides of the guide block (F).

2.Adjust the length of the guide by pulling out or pushing inward to achieve the desired length as shown in Figure 11.

3.Secure the guide in place by turning the depth/cut adjustment knob (N) clockwise. To release the guide, turn the depth/cut adjustment knob counterclockwise.

FIG. 10	FIG. 11
	F
	G	N
NOTE: The guide arm can also be placed in		FIG. 12
the guard assembly vertically in order to set

the height of a cut. Refer to Figure 12.

OPERATION

WARNING: To reduce the risk of injury, turn unit off and disconnect it from power source before installing and removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.

WARNING: Ensure switch is fully OFF before plugging in the power cord.

1.	Plug in power cord.		FIG. 13
2.	To turn the tool ON, hold it as
	shown in Figure 13 and press the
	variable speed trigger (A).
	NOTE: The further the trigger
	switch is depressed, the faster
	the tool will operate. If	in doubt	A
	about the proper speed	for your

operation, test the performance at low speed and gradually increase until a comfortable speed is found.

3. To turn the tool OFF, release the variable speed switch (A).

Lock-on Button (Fig. 14)	FIG. 14
Pushing the lock-on button (D) to the left or
right with the trigger depressed will lock the
trigger in the depressed position. This allows
for more comfort and control in extended
use applications. Pressing the trigger switch	D
again will release the lock and the tool will	A
turn off upon release of the trigger.

7

English