Pelco es3012 Operation, Power-Updisplay, Operating Notes Environmental Range, How to Control

OPERATION

POWER-UP DISPLAY

When the Esprit system is powered up or reset, the selected protocol, revision number, and other information is displayed on the monitor. For example, the screen might show the fol- lowing information:

PELCO ESPRIT 1.20 CONFIGURE DONE

D Address 1

P Address 2

The information displayed depends on the selected protocol (C, D, or P) and the menu selection for power-up mode. (Refer to the Power-Up Mode in the Programming section).

The information remains on the monitor until the dome is moved.

HOW TO OPERATE YOUR ESPRIT INTEGRATED POSITIONING SYSTEM

Operation	How to Control
Pan and Tilt	Move joystick left/right and up/down.
Scanning
Stop Scan	Call preset 96.
Random Scan	Call preset 97.
Frame Scan	Call preset 98.
Auto Scan	Call preset 99.
Presets	Refer to the documentation supplied with the controller.
Patterns	Refer to the documentation supplied with the controller.
Zones	Refer to the Programming section and to the
	documentation supplied with the controller.

For more information refer to Operating Notes.

OPERATING NOTES

ENVIRONMENTAL RANGE

The operating temperature ranges from a minimum of -40°F (-40°C) to a maximum of 122°F (50°C) for sustained system operation or 140°F (60°C) absolute maximum. The entire unit can de-ice and be operational in two hours from a temperature of -13°F (-25°C). The thermo- statically controlled heater consumes 10 watts and cycles on at 70°F (21°C) and off at 85°F (29°C), while the window defroster runs continuously and consumes 2.5 watts.

PAN AND TILT FUNCTIONS

Controller	Pan	Tilt
Type	(Capability, 360° Continuous	(Viewing Range, +40° to -90°)***
	Pan Rotation)**
Fixed speed	Speed determined by	Speed determined by controller
	controller
*Variable speed	0.5 to 40° per second,	0.5 to 20° per second, depending
	depending on joystick position	on joystick position
*Turbo Mode	100° per second	Does not affect the tilt speed
*Preset Mode	100° per second	30° per second

*50 mph wind speed profile.

**If manual limit stops are set, “Pan Limit” appears on your monitor when a limit stop is reached. This does not apply to scan limit stops.

***When the system reaches the upper limit, “Tilt Limit” appears on your monitor.

14 Pelco Manual C306M-K (4/05)