Pelco es3012 installation manual PAN/SCAN Speed, Park Time, Pattern Length

PAN/SCAN SPEED

The pan/scan speed is adjustable from 3-40 degrees per second. This occurs in three scan modes: auto, random, and frame scan.

To change the pan/scan speed:

1.Program preset 95 (28). The main menu appears.

2.Position the cursor (>) beside Other.

3.Press the Iris Open button to enter the Other menu.

4.Position the cursor (>) beside Pan/Scan Spd.

5.Press the Iris Open button. The cursor moves to the right beside the number of degrees.

6.Move the joystick up or down to toggle through the number of degrees (3-40) until you reach the number you want. (If set on a low number, the scan appears to barely move but is still functioning.)

7.SELECT - Press the Iris Open button on your keyboard to select your choice. CANCEL - Press the Iris Close button if you do not want to change the setting.

PARK TIME

NOTE: Preset 1 must be programmed for the system to park.

This feature causes the pan and tilt to park at preset 1 after a programmed number of min- utes of control inactivity. The time can be set from 1 minute to 720 minutes (12 hours), or it can be set to zero, which disables this feature.

To change the park time:

1.Program preset 95 (28). The main menu appears.

2.Position the cursor (>) beside Other.

3.Press the Iris Open button to enter the Other menu.

4.Position the cursor (>) beside Park Time.

5.Press the Iris Open button. The cursor moves to the right beside the current park time.

6.Move the joystick up or down to change the park time.

7.SELECT - Press the Iris Open button on your keyboard to select your choice. CANCEL - Press the Iris Close button if you do not want to change the setting.

PATTERN LENGTH

CAUTION: If the length is changed, all stored patterns

are erased.

The system can do either:

One full pattern - 1.5, 3, or 6 minutes long or

Two half patterns - .75, 1.5, or 3 minutes long

To set the pattern length:

1.Program preset 95 (28). The main menu appears.

2.Position the cursor (>) beside Other.

3.Press the Iris Open button to enter the Other menu.

4.Position the cursor (>) beside Pat Length.

5.Press the Iris Open button. The cursor moves to the right, beside the number of minutes (1.5, 3, or 6).

6.Move the joystick up or down to toggle through the number of minutes (1.5, 3, or 6).

7.SELECT - Press the Iris Open button on your keyboard to select your choice. CANCEL - Press the Iris Close button if you do not want to change the setting.

26 Pelco Manual C306M-K (4/05)