DeWalt DWE575SB Save These Instructions for Future USE, Motor, Components Fig

English

•Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction activities. Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote absorption of harmful chemicals.

WARNING: Use of this tool can generate and/or disperse dust, which may cause serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct particles away from face and body.

WARNING: Always wear proper personal hearing protection that conforms to ANSI S12.6 (S3.19) during use. Under some conditions and duration of use, noise from this product may contribute to hearing loss.

•The label on your tool may include the following symbols. The symbols and their definitions are as follows:

V			volts	A			amperes
Hz			hertz	W			watts
min			minutes			..... alternating current
		....direct current				..... alternating or direct current
			Class I Construction	no			no load speed
	.........
.............			(grounded)			......	earthing terminal
	.........		Class II Construction		.......		safety alert symbol
.............			(double insulated)	BPM ..			beats per minute
…/min ..			per minute	RPM ..			revolutions per minute
IPM			impacts per minute	sfpm ..			surface feet per minute

SAVE THESE INSTRUCTIONS FOR

FUTURE USE

Motor

Be sure your power supply agrees with the nameplate marking. Voltage decrease of more than 10% will cause loss of power and overheating. DEWALT tools are factory tested; if this tool does not operate, check power supply.

FIG. 1		B
	A	C	D
L
			E
K			F
J
			G
I			H

COMPONENTS (Fig. 1)

WARNING: Never modify the power tool or any part of it. Damage or personal injury could result.

A.	Trigger switch	H.	Foot plate
B.	Main handle	I.	Lower blade guard
C.	Blade lock	J.	Blade clamping screw
D.	End cap	K.	Lower guard lever
E.	Auxiliary handle	L.	Upper blade guard

F.Bevel adjustment lever

G.Bevel angle adjustment mechanism

6