DeWalt WRVS4400N manual Setting Up and Configuring the Router

Setting Up and Configuring the Router

L2 Switch Tab

•General—All frames can be tagged or untagged coming in to the switch. If it is untagged, default PVID will apply to the packet. Only the General mode users can choose the following two options.

NOTE: The following cannot be supported on Vitesse 7385 switch chipset

–Acceptable Ingress Frame Type—All Frames: all the incoming frames are acceptable.

Tagged Only: only tagged incoming frames are acceptable

–Ingress Filtering—Check the VLAN ID on the incoming packet. If the port is a member of this VLAN, accept the frame. Otherwise, drop it. If not enabled, all frames are accepted.

•PVID—The VLAN ID of the default (untagged) VLAN

The second section is per VLAN settings to be used with each port. It requires users to specify each VLAN to be tagged, untagged, or excluded on the specific port.

•VLAN— Select a VLAN ID to be configured

•VLAN NAME— VLAN description (read-only) to help user identify this VLAN

•Tagged— Egress frames from this port is tagged for this VLAN

•Untagged—Egress frames from this port is untagged for this VLAN

•Excluded—The port does not participate in this VLAN at all

For Access port, the available options are either untagged or excluded. Therefore, wireless port can set to one of these two modes for each VLAN. Only one of the VLAN ID can be selected (untagged).

For Trunk port, the options are tagged or excluded for all VLAN IDs except VLAN 1. VLAN 1 must be untagged.

For General port, the options are tagged or untagged for PVID; tagged or excluded for all other VLAN IDs.

The third section is a summary of VLAN subscriptions on each port. "U" means untagged while "T" means tagged.

WRVS4400N User Guide 97