WRVS4400N User Guide 82
Administration Tab
Setting Up and Configuring the Router
SNMP
Configures the Simple Network Management Protocol settings. Users can use management
software to read or write information from or to the device.
SNMP—Select Enable if you wish to use SNMP. To use SNMP, you need SNMP software on your
PC.
System Name—Enter a suitable name. This name will be used to identify this device, and will
be displayed by your SNMP software.
System Contact—Enter contact information for the system.
System Location—Enter the location of the system.
Read Community—Enter the SNMP community name for SNMP “Get” commands.
Write Community—Enter the SNMP community name for SNMP “Set” commands.
Trap Community—Enter the SNMP community name for SNMP "Trap" commands.
Trap To—Enter the IP Address of the SNMP Manager where traps will be sent. If desired, this
may be left blank.
UPnP
UPnP—Universal Plug and Play allows Windows MP and XP to automatically configure the
Internet Gateway on its routing table. If you want to use UPnP, keep the default setting, Enable.
Otherwise, select Disable.
WLAN
Management via WLAN—Control the access of Web based GUI from associated wireless
clients. The default is Disable.
Change these settings as described here and click Save Settings to apply your changes, or click
Cancel Changes to cancel your changes. Help information is displayed on the right-hand side
of the screen, and click More for additional details.
Log
This screen provides you options on how you want to manage your system logs. The Wireless
Router provides four categories of event logging (Firewall, VPN, System, and ACL). You can