DeWalt WRVS4400N manual Vlan & QoS

Setting Up and Configuring the Router

Wireless Tab

DTIM Interval—Indicates how often the Wireless Router sends out a Delivery Traffic Indication Message (DTIM). Lower settings result in more efficient networking, while preventing your PC from dropping into power-saving sleep mode. Higher settings allow your PC to enter sleep mode, thus saving power, but interferes with wireless transmissions. The default is 1 ms.

RTS Threshold— Determines how large a packet can be before the Wireless Router coordinates transmission and reception to ensure efficient communication. This value should remain at its default setting of 2346. If you encounter inconsistent data flow, only minor modifications are recommended.

Change these settings as described here and click Save Settings to apply your changes, or click Cancel Changes to cancel your changes. Help information is displayed on the right-hand side of the screen, and click More for additional details.

VLAN & QoS

Configure the Qos and VLAN settings for the Access Point. The QoS (Quality of Service) feature allows you specify priorities for different traffic. Lower priority traffic will be slowed down to allow greater throughput or less delay for high priority traffic. The 802.1Q VLAN feature is allowing traffic from different sources to be segmented. Combined with the multiple SSID feature, this provides a powerful tool to control access to your LAN.

VLAN

Enabled/Disabled VLAN—Enable this feature only if the hubs/switches on your LAN support the VLAN standard.

AP Management VLAN—Define the VLAN ID used for management.

VLAN ID—Enter the VLAN ID.

QoS

U-APSD(WMM Power Save)—Select Enabled or Disabled as required.

WMM—Wi-Fi Multimedia is a QoS feature defined by WiFi Alliance before IEEE 802.11e was finalized. Now it is part of IEEE 802.11e. When it is enabled, it provides four priority queues for

WRVS4400N User Guide 56