Manuals / Diamond Systems / Computer Equipment / Computer Hardware

Diamond Systems PR-Z16-LC-ST user manual Output Power - J12, USB - J5

Models: Low-Power PC/104 CPU Board With ZFx86 Processor PR-Z16-LC-ST

1 38

Download 38 pages 57.37 Kb

Page 10

4.3 Output Power – J12

4.3 Output Power – J12

1

2

3

4

+5V Out

Ground

Ground

+12V Out

J12 provides switched power for use with external drives. If ATX is enabled, the power is switched on and off with the ATX input switch. If ATX is not enabled, the power is switched on and off in conjunction with the external power.

Diamond Systems’ cable no. 698006 mates with J12. It provides a standard full-size power connector for a hard drive or CD-ROM drive and a standard miniature power connector for a floppy drive.

4.4 USB – J5

Key (pin cut)	1	2	Shield
USB2 Pwr-	3	4	USB1 Pwr-
USB2 Data+	5	6	USB1 Data+
USB2 Data-	7	8	USB1 Data-
USB2 Pwr+	9	10	USB1 Pwr+

J5 is a 2x5 pin header. It mates with Diamond Systems’ cable no. 698012, which provides 2 standard USB type A jacks in a panel-mount housing.

Prometheus-LC CPU User Manual V1.0

Page 10

Image 10

Diamond Systems PR-Z16-LC-ST, Low-Power PC/104 CPU Board With ZFx86 Processor user manual Output Power - J12, USB - J5

Contents

Model PR-Z16-LC-ST Low-Power PC/104 CPU Board With ZFx86 Processor PROMETHEUS-LCJUMPER CONFIGURATION TABLE OF CONTENTSFEATURES SYSTEM FEATURESI/O PANEL BOARD TABLE OF CONTENTS CONTINUEDVGA ACCESSORY BOARD FLASH DISK PROGRAMMER BOARD1. DESCRIPTION PROMETHEUS-LC Low-Power PC/104 CPU Board with ZFx86 ProcessorSystem Features 2. FEATURES System FeaturesProcessor Section J14 Not present 3. PROMETHEUS-LC BOARD DRAWINGJ4 Not present J13 Not presentCable “A” 4.1 Main I/O Connector - J34. I/O HEADERS Cable “B”Notes on J3 Signals Connector Part Numbers4.2 Input Power - J11 4.3 Output Power - J12 4.4 USB - J5Do not use both J15 and the corresponding pins on J3 simultaneously 4.5 Auxiliary Serial Port Connector - J154.6 Watchdog/Failsafe Features - J6 4.7 Floppy Drive - J7 4.8 IDE Drive - J8J1 PC/104 8-bit bus connector 4.9 PC/104 Bus ConnectorsJ2 PC/104 16-bit bus connector View from Top of Board5. JUMPER CONFIGURATION 5.1 System Configuration - J105.2 Watchdog Timer & System Recovery - J6 6.2 CPU Chip Selects 6. SYSTEM FEATURES6.1 System Resources Device6.3 Console Redirection to a Serial Port There are three possible configurations for console redirection6.4 Watchdog Timer 6.8 System Reset 6.5 Failsafe Mode / BIOS Recovery6.7 Backup Battery 6.6 Flash Memory7. BIOS FEATURES 7.1 BIOS SettingsPC Serial Port End DB-9 7.2 BIOS Download / Recoveryzftrm.exe loadbios.com prm1.rom Prometheus-LC COM1 end8. DISK-ON-BOARD FLASH FILE STORAGE Initial SetupOperating System Formatting Life Cycle Management and Calculations Known LimitationsLifetime in days = number of file writes / file writes per day 9.1 Serial Ports 9. SYSTEM I/O9.2 Parallel Port 10.NOTES ON OPERATING SYSTEMS AND BOOTING PROCEDURES 10.1 Installing an OS From a Floppy Drive onto a Flashdisk Module10.2 Installing an OS from a Hard Disk onto a Flashdisk Module 11.3 Using the Flashdisk with Another IDE Drive 11.1 Installation11.2 Configuration 11.4 Power Supply12. I/O PANEL BOARD 12.1 DescriptionPanel Board Bottom Side / Internal Use I/O Connectors 12.2 Panel Board I/O ConnectorsPanel Board Top Side / External Use I/O Connectors Location12.5 Panel Board Power Connections J12 pinout to/from DC/DC power supplyJ13 pinout user connection 12.6 Speaker and Miscellaneous Connector J3 Pinout12.7 Watchdog Timer J9 Pinout 12.8 Installation13.FLASH DISK PROGRAMMER BOARD ACC-IDEEXT FlashDisk Programmer BoardCable No 14.I/O CABLESPhoto No Cable Kit C-PRZ-KITJ25 Signal 15.VGA ACCESSORY BOARDPL5 Signal SignalManufacturer Connector on Board16.MOUNTING PROMETHEUS-LC ON A BASEBOARD Manufacturer Part NoPrometheus-LC CPU User Manual Page17.PC/104 MECHANICAL DRAWING Prometheus-LC CPU User Manual