Digicom ED-20 PPP ED-Tool for ED-20 commands, General commands, Cable is connected to

8.1.1 ED-Tool for ED-20 commands

This section describes the ED-Tool for ED-20 commands. The commands are described by there use.

Details about allowed values and default values is described is section 6.2.

1

2

3

4

57600

RTS/CTS

5

6

8.1.1.1 General commands

1		Selects type of connection, Serial or over the Network.
		If ‘Serial’ is selected, use the “Tools menu – Serial COM port” to
		select which of COM1:, COM2:, COM3:, or COM4: your serial
		cable is connected to.
2	Read Config	Reads configuration from the ED-20.
3	Write Config	Writes configuration to the ED-20.
		Note! ED-20 must be rebooted before any new configuration
		is activated.
4	Reboot	Reboots the ED-20.

8.1.1.2 Serial Interface – Channel 1 specific commands

5	Data Rate	Selects Data Rate for serial communication, ED-20 – Modem.
6	Flow Control	Selects if flow control is used or not.
		Note! All interconnecting wires are required between the ED-20
		and the attached modem.

6609-2221 17