Digicom ED-20 PPP installation manual Modem Settings

1

2

3

4

5

6

7

			PSTN		AT&F&DOSO		ATH
			DIAL IN/OUT		OK		OK
			NO
				3		3
			NO	1		1
+++
		2
					ATDS=0		RING
	600
					CONNECT		ATA
				60		0
				1

8.1.1.3 Modem Settings

General
1	Modem	Select Type of connection, PSTN or LL.
	Connection	•	Use PSTN for dial-up connections, e.g. Phone modem, GSM
			modem or ISDN adapter.
		•	Use LL for fixed connections, e.g. LeasedLine-, Radio-, Fibre-
			or any Short-haul- modem.
2	Dial IN/OUT	Select if the ED-20 shall act as a PPP Server, PPP Client or both.
		When the unit is set to be a server, it will answer incoming calls.
3	Connect at	Select if the ED-20 shall initiate a connection at power on
	PWR On	with the Modem Connect (Dial Out) command.
4	DCD Control*	Select if the ED-20 shall disconnect the PPP link at modem DCD
		loss.
		Note! All interconnecting wires are required between the ED-20
			and the attached modem.
5	Escape	Set the modem escape sequence wich switches the modem into
	Sequence	command mode. Not used for Leased Line mode. Usually ‘+++’.
6	Escape Delay	Set the delay time in seconds after the escape sequence before
		any other command.
7	Idle Time	Set the idle time in seconds, after which the PPP server closes the
		connection if no data being sent.
18			6609-2221