| 2002 @ Home Hot Tubs |
| Owner’s Manual |
|
|
Control | Function |
4 | 4.HEAT Indicator Light |
| This Light is illuminated the heater is on. |
|
|
5 | 5. JETS 1 Pad and Status Light |
| When the JETS 1 control pad is pushed the first time, the primary pump will |
| turn on in low speed. When the JETS 1 pad is pressed a second time, the |
| primary pump will switch to high speed. Push the JETS 1 pad a third time and |
| the primary pump will be turned off. |
| NOTE: The Dream HP, Sojourn HP and Cove HP are dual pump spas. The |
| upper control panel will have two jet pads (JETS 1 and JETS 2). The primary |
| pump (JETS 1) is a |
| secondary pump (JETS 2) is a single speed pump with only one speed setting. All |
| other @Home Hot Tubs have one two speed jet pump and therefore have only |
| one jet pad. If the spa is heating, pump one will run continuously at low speed |
| until the |
| when the display is showing the water temperature set point. It will be off when |
| the display is showing the actual water temperature. |
| NOTE: When a bather turns on a pump by pressing either JETS 1 or JETS 2, it |
| will run for 30 minutes and then turn off. A new 30 minute cycle begins for |
| each pump when its respective JETS pad is pushed. This auto |
| safety feature and also allows for convenient filtration, immediately after use of |
| the spa. |
|
|
6 | 6. JETS 2 Pad |
| If your hot tub is equipped with a secondary pump (Dream HP, Sojourn HP and |
| Cove HP) then you will have a JETS 2 pad. The first time the JETS 2 pad is |
| pushed it will start the secondary (single speed pump) and when pushed a |
| second time it will stop the secondary pump. |
|
|
7 | 7. LIGHT Pad and Status Light Push the LIGHT control pad once to turn |
| the light on. Push the LIGHT control pad a second time to turn off the light. |
| The light LED is on or off according to the light’ current state. The light will |
| automatically turn off after 1 hour of continuous operation. |
| NOTE: If the Dynamic L.E.D. is installed, the low, medium, and high settings |
| are disabled. The Light pad turns the Dynamic L.E.D. on and off. |
|
|
10