Dimplex DF2603 manual Maintenance, a,b,c, D. Heater On/Off Switch, E. Heater Thermostat Control

D. HEATER ON/OFF SWITCH

The heater on/off switch supplies power to the heating unit when main on/off switch (A) is on.

E. HEATER THERMOSTAT CONTROL

To adjust the temperature to your individual requirements, turn the thermostat control clockwise all the way to turn on the heater. When the room reaches the desired temperature, turn the thermostat knob counter clockwise until you hear a click. Leave in this position to maintain the room temperature at its setting. For additional heat, turn clockwise until you hear the click again and the heater will turn on. To lurn the heater off, rotate the knob fully counter clockwise.

NOTE

• The heater may emit a slight, harmless odor when first used. This odor is a normal condition caused by initial heating of internal heater parts and will not occur again.

3. To conceal the controls during operation, return the grill to its original upright position.

MAINTENANCE

a

REMOVING￿GLASS

b

REPLACING￿GLASS

c

RETAINING￿CLIP

HOLDING￿GLASS

WARNING

-Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons.

￿Light Bulb Replacement:

NOTE

·Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid accidental burning of skin.

Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log exterior disappears. There are two bulbs at the top of the opening which illuminate the log set exterior, and four bulbs under the log set which generate the flames and embers.

Tool Requirements: Slot Screw Driver

6

FIGURE￿10￿(a,b,c)