Dimplex DF2603 manual Site Selection And Preparation, Cord

SITE SELECTION AND PREPARATION

26”

This section provides easy step by step instructions for selecting a location and preparing the site to install the Fireplace into:

￿Existing Fireplace

￿New Wall Construction

￿Dimplex Mantel Surround Kit or custom made mantel surround

22￿1/2”

AIR￿CIRCULATION AREAS

12"

NOTE

•The Fireplace Insert comes completely assembled and wired. Some tools may be required to prepare the site and assemble/install the trim.

•The dimensions of the Fireplace Insert are 26" wide (66cm) X 22 1/2" high (57.2cm) X 12" deep (30.5cm). (FIGURE 1) You may want to leave a clearance around the insert of 1/4" (O.6cm) to ease installation .

•This Fireplace Insert does NOT require venting.

FIGURE￿1

CAUTION

·Clearance for air circulation beneath the fireplace insert is provided by three rubber feet (FIGURE 1). DO NOT INSTALL THE FIREPLACE INSERT DIRECTLY ON CARPET OR SIMILAR SURFACES WHICH MAY RESTRICT AIR CIRCULATION. If installing the fireplace in a carpeted area, place a one-piece, solid, flat surface under the fireplace insert. Ensure that all three of the insert's feet rest securely on this surface .

￿Existing Fireplace:

1.Seal all drafts and vents with non-fiberous insulation materials to prevent chimney debris from falling onto the Fireplace Insert. Do not install into an existing fireplace that is prone to dampness.

2.Cap the top of the chimney flue to prevent rain from entering

3.Plan your electric power supply: (Refer to Note 1)

4.The power cord can run along the front of the hearth to an outlet near the fireplace. (FIGURE 2)

FIGURE￿2

CORD

2