Directed Audio XTR5004, XTR2504 owner manual CEA Specifications

	Figure 2, Figura 2
1 2 3	Abbildung 2

1.+BAT - connect this terminal through a FUSE or CIRCUIT BREAKER to the positive terminal of the vehicle battery or the positive ter- minal of an isolated audio system battery

WARNING: Always protect this power wire by installing a fuse or circuit breaker of the appropriate size within 12 inches of the battery terminal connection..

2.REM - this terminal turns on the amplifier when (+) 12 volt is applied.. Connect it to the remote turn on lead of the head unit or signal source.. If a (+) 12 volt remote turn lead is not available, a Remote Power Adapter (P/N #ORRPA) can be used to supply a remote turn on signal.. DO NOT connect this terminal to constant

(+) 12 volt

3.GND - power return connection.. Connect this terminal directly to the sheet metal chassis of the vehicle, using the shortest wire necessary to make this connection.. Always use wire of the same gauge or larger than the (+) 12 volt power wire.. The chassis con- nection point should be scraped free of paint and dirt.. Use only quality crimped and/or soldered connectors at both ends of this wire.. DO NOT connect this terminal directly to the vehicle battery ground terminal or any other factory ground points

CEA Specifications

XTR2504

Power Output: 50 Watts RMS x 4 at 4 ohms and

< 1% THD+N

Signal to Noise Ratio: >80 dBA (reference 1 Watt

into 4 ohms)

Additional Power: 70 Watts RMS x 4 at 2 ohm and < 1% THD+N

XTR5004

Power Output: 80 Watts RMS x 4 at 4 ohms and

< 1% THD+N

Signal to Noise Ratio: >80 dBA (reference 1 Watt

into 4 ohms)

Additional Power: 125 Watts RMS x 4 at 2 ohm and < 1% THD+N

© 2008 Directed Electronics. All rights reserved. 4