43
7Use
GB
7Use

7.1 Cleaning hard floors

1. Place the appliance in the middle of the
room to be cleaned.
2. Turn on the cleaning robot using the On/
Off switch (Fig. 19).
The two outside LEDs will be flashing al-
ternately.
After approx. 8 seconds the appliance will
start to move in "random mode" passes
(Fig. 20/A).
After approx. 3 minutes the appliance
changes to "gyro mode" and moves in ev-
er larger circles (Fig.20/B).
In this mode, as soon as the appliance en-
counters an obstacle, it changes to "edge
mode" (Fig. 21/A). In this mode it travers-
es the edges of the room to be cleaned for
approximately 3 minutes.
Thereafter the cycle starts all over again
(Fig. 21/B).
If the appliance keeps hitting an object,
give it a light shove with your hand.
You can switch off the appliance at any
time.
When the capacity of the battery pack di-
minishes, the battery indicator " " will be
continuously illuminated red and the appli-
ance will stop a short while later.
- If this is the case, the robot will then
beep every 60 seconds so that you can
easily find it. If the battery pack is com-
pletely empty, even this beep function
will stop.
- In this case, switch off the appliance and
charge the battery pack as described,
Chapter 5, ‘Charging the battery pack
in the appliance’.
WARNING:
Danger of injury! You can let the appliance
run unsupervised, however always be care-
ful not to step on it, this could cause you to
fall.
19
A
B
20
21
ATTE NTION:
Although your cleaning robot recognises
drop-offs, we strongly advise against using
it on furniture and similar objects. It is not
suitable for this type of use.
M607.book Seite 43 Dienstag, 18. Juni 2013 10:44 10