Dixon Aficio 1515

Preparing to Print

•Windows Me

AIn the [Add New Hardware Wiz-

ard] dialog box, confirm that

[Windows has found the follow-

ing new Hardware: IEEE SBP-2

Device] is displayed, and click

[ Recommended search for a bet-

ter driver [Recommended]], and

then click [Next].

BWhen “Windows was unable

to locate the software for this

device.” appears, click [Fin-

ish].

❖

❖❖

❖If you do not want to install the printerwhen [Found New Hardware Wizard]starts when using an operating sys-tem that supports SCSI print, disablethe device with the following proce-dure:

•Windows 2000

AIn the [Found New Hardware

Wizard] dialog box, click

[Next].

BWhen “This wizard will com-

plete the installation for this

Device: Unknown” appears,

click [Search for a suitable driv-

er for my device [recommend-

ed]], and then click [Next].

CWhen “Locate Driver Files ”

appears, remove all selec-

tions from [Optional search lo-

cations.], and then click [Next].

DWhen “Driver Files Search

Results” appears, click [Disa-

ble the device. The Add/Remove

Hardware Wizard in the control

panel can be used to complete

the driver installations.], and

then click [Finish].

•

Windows XP and Windows Serv-

er 2003

In the

[Found New Hardware Wiz-

ard]

dialog box,

confirm “This

wizard helps you install soft-

ware for: Unknown” is dis-

played, and click [Install from

a list or specific location (Ad-

vanced)], and then click [Next].

BWhen “Please choose your

search and installation op-

tion.” appears, remove all se-

lections from [Search for the

best driver in these locations.],

and then click [Next].

CWhen “The wizard could not

find the software on your

computer for..” appears,

click [OK].

DWhen “Cannot Install this

Hardware” appears, select

the [Don't prompt again to install

the software] check box, and

then click [Finish].

❖

❖❖

❖If [Found New Hardware Wizard] ap-pears every time you restart the com-puter when using an operatingsystem that does not support IP over1394, or plug in/take out the cable,disable the device with the followingprocedure:

•Windows 2000

AIn [Found New Hardware Wiz-

ard] dialog box, click [Next].

BWhen “This wizard will com-

plete the installation for this

Device:” and “IP over 1394”

appear, click [Search for a suit-

able driver for my device [recom-

mended]], and then click

[Next].

CWhen “Locate Driver Files”

appears, remove all selec-

tions from [Optional search lo-

cations.], and then click [Next].

StellaC2-GB-Pref1-F3_FM_ZF.book Page 34 Friday, November 21, 2003 8:42 PM