| SPECIFICATIONS | |
|
| Model ZTR 5022 |
CHASSIS: | 11 GA - rectangular tube | |
BODY: | Two piece - made of | |
| panels for battery service and engine to mower deck belt removal. Rear body | |
| tilts up to allow service on the entire drive system. | |
SEAT: | Designed for operator comfort by use of high density closed cell foam padded | |
| back and arm rests, upholstered with CorduraTM | |
| adjustable fore and aft. | |
MOWER DECK: | 42" Deck: | 13 GA Stamped Steel Construction - 42" Cut Width |
| 50" Deck: | 11 GA Fabricated Construction/Reinforcement Ribs - 50" Cut Width |
| 60" Deck: | 10 GA Stamped Steel Construction - 60" Cut Width |
|
| Cut height approximately 1" to 4" via 7 position lift handle |
BLADE DRIVE: | Electric clutch | |
DRIVE SYSTEM: | Each rear wheel is independently driven by a HydroGear | |
| hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully | |
| enclosed HydroGear gearbox. | |
ENGINE: | 22HP Kohler Command, | |
| Gasoline, Vertical Shaft, Aluminum Head, and Crankcase with Cast Iron Liners, | |
| Full Pressure Lubrication/Full Flow Filter, | |
| Carburetor | |
| Air Cleaner. | |
STARTING SYSTEM: | Electric by key switch operation with safety interlocks on parking brake and | |
| blade drive clutch. | |
TIRES: | Front | 11 X 4 X 5 ribbed tread |
| Rear | 20 X 10 X 8 Multi Trac |
RECOMMENDED | Front | 16 - 21 lbs. |
TIRE PRESSURE: | Rear | 8 - 14 lbs. |
CAPACITIES: | Fuel - 4.8 gallons total (dual tanks) | |
| Hydrostat oil tank - 3 quart with | |
| Hydrostat oil recommendation, refer to page 35 | |
| Engine - 2 qts. SAE 10W30 (with filter) | |
DIMENSIONS: | Width | 51"(42" Deck), 60"(50" Deck), 72"(60" Deck) |
| Height | 45" |
| Length | 72" |
| Weight | 615 lbs.(42" Deck), 680 lbs.(50" Deck), 685 lbs.(60" Deck) |
NOTE: | Additional information provided in service instructions under the individual component. | |
| SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE | |
Page 14
