CARE AND MAINTENANCE
NEUTRAL ADJUSTMENT:
1.Engage parking brake, and raise rear of frame with jack or blocks so that rear tires do not contact the ground.
2.Swing out the control levers, start the engine, and release the parking brake.
3.Raise the upper body to access hydro control linkage. If right wheel creeps, adjust right side linkage and
a.loosen, but do not remove, the bolt in the control tube (5540)
b.loosen jam nuts on ends of the control rod (9067)
c.turn control rod in or out until neutral is achieved
d. tighten jam nuts on control rod e. tighten bolt in control tube
JAM NUTS LOOSEN
INSTEPBTIGHTENIN
STEPD
CONTROLTUBEBOLT
LOOSEN IN STEP A
4. Engage parking brake and lower the body.
TIGHTENINSTEPE
Release parking brake and swing control levers in. If wheel creeps, repeat step 3.
5. Stop engine and remove rear of machine from jack or blocks.
Page 37
