Check the engine’s oil level | Husqvarna 1030 BioClip, 1200 instruction

MAINTENANCE

Check the engine’s oil level

Check the oil level in the engine when the machine is horizontal.

Dismantle the engine hood as per the description on page 18.

Take out the dip stick, wipe off the oil, and insert again.

The dip stick must be fully screwed down.

Now take out the dip stick again and check the oil level.

The oil level should lie between the markings on dip stick. If the level approaches the ADD mark, top up with oil to the FULL mark on the dip stick.

The oil is filled in the same hole as the dip stick is in.

Use engine oil SAE 30 or SAE 10W-30, class CD– CF (over 0°). Use engine oil SAE 5W-30, class CD–CF (below 0°).

The total oil volume in the engine is 1.3 litres.

	ADD	FULL
ADD	FULL

Check the engine’s cooling air intake

Dismantle the engine hood as described on page 18.

Check that the cooling intake is free from leaves, grass and dirt.

If the cooling intake is blocked this will interfere with the cooling of the engine, which can damage the engine.

Checking of the fuel pump’s air filter

Check regularly that the fuel pump’s air filter is free from dirt.

The filter can when necessary be cleaned with a brush.

English – 19

Image 21

Husqvarna 1030 BioClip, 1200 manual Check the engine’s oil level, Check the engine’s cooling air intake

Contents

101 89 Rider 1030 BioClip Rider Svenska Contents Safe operation practices for ride-on mowers Safety InstructionsGeneral operation II. Slope operation IV. Service Read the instructions Explanation of Symbols General use These instructions are for your safety. Read them carefully Do as follows Driving on slopes Maintenance ChildrenDo not do the following Never drive the machine in an enclosed space Presentation PresentationLocation of the controls Throttle control Choke leverSpeed limiter Lift lever for cutting unit Cutting unit Parking brake Lever for adjustment of the cutting heightSeat Fuelling Driving Before startingStarting the engine Driving the machine Cutting tips Stopping the engine MAXDisengage lever Maintenance schedule MaintenanceDaily Maintenance interval Hours Engine hood Dismantling of the machine hoodsFront hood Right-hand fender Check the engine’s oil level Check the engine’s cooling air intakeChecking of the fuel pump’s air filter Check the transmission’s oil level Check the transmission’s air intake Checking and adjustment of the steering wires Check the level of the battery acid Checking and adjusting the brakeCheck the safety system Poorly adjusted brakes can result in reduced braking power Replacing the air filter Do not use compressed air to clean the paper filter Maintenance Checking and adjusting the cutting unit’s parallelism Checking the blades Dismantling the cutting unit Changing the oil Replacement of the oil filter LubricationGeneral lubrication Checking and adjustment of the throttle wire Checking the tyre pressure Replacement of the fuel filter Problem Procedure Trouble Shooting Schedule Service StorageWinter storage Wiring Diagram Rider 1030 Bioclip, Rider Technical Data English «*2h6+¬ English «*2h6+¬