Husqvarna 1030 BioClip, 1200 manual Checking and adjusting the cutting unit’s parallelism

MAINTENANCE

Checking and adjusting the cutting unit’s parallelism

To achieve good mowing results it is important that the unit is parallel with the ground.

Check this as follows:

1. Place the machine on a level surface.

2. Measure the distance between the ground and the edge of the unit, at the front and back of the hood.

If the values are the same the cutting unit is parallel.

If the cutting unit needs adjusting, do as follows:

1.Dismantle the front hood and right-hand and left- hand fenders as described on page 18.

2.Release the lock-nuts (1) and (2). Note that the strut ends are right and left threaded.

3.Place a wrench over the bevel (3) in the middle of the strut and screw the strut forwards to raise the front edge of the hood, or backwards to lower it.

4.Tighten the lock nuts after the adjustment.

5.On completion of the adjustment the unit’s parallelism should be re-checked.

Fit the left-hand and right-hand fenders and the front hood.

1

2

3

English – 25