Dismantling of the machine hoods, Engine hood | Husqvarna 1200

MAINTENANCE

Dismantling of the machine hoods

Engine hood

Release the two rubber straps on the rear edge of the engine hood and lift off the hood.

Front hood

Dismantle the screws (1, 2 and 3) and lift off the front hood.

Right-hand fender

Dismantle the foot-plate (1), screws (2 and 3), and lift off the fender.

3

2

1

2

1

3

Left-hand fender

Dismantle the screws (1 and 2), and lift off the fender.

1

2

18 – English

Image 20

Husqvarna 1200 manual Dismantling of the machine hoods, Engine hood, Front hood, Right-hand fender, Left-hand fender

Contents

Rider 1030 BioClip Rider 101 89 Svenska Contents Safety Instructions Safe operation practices for ride-on mowersGeneral operation II. Slope operation IV. Service Explanation of Symbols Read the instructions These instructions are for your safety. Read them carefully General use Driving on slopes Do as follows Do not do the following MaintenanceChildren Never drive the machine in an enclosed space Location of the controls PresentationPresentation Speed limiter Throttle controlChoke lever Cutting unit Lift lever for cutting unit Lever for adjustment of the cutting height Parking brakeSeat Fuelling Starting the engine DrivingBefore starting Driving the machine Cutting tips Disengage lever Stopping the engineMAX Maintenance Maintenance scheduleDaily Maintenance interval Hours Dismantling of the machine hoods Engine hoodFront hood Right-hand fender Checking of the fuel pump’s air filter Check the engine’s oil levelCheck the engine’s cooling air intake Check the transmission’s air intake Check the transmission’s oil level Checking and adjustment of the steering wires Checking and adjusting the brake Check the level of the battery acidCheck the safety system Poorly adjusted brakes can result in reduced braking power Do not use compressed air to clean the paper filter Replacing the air filter Maintenance Checking and adjusting the cutting unit’s parallelism Dismantling the cutting unit Checking the blades Changing the oil General lubrication Replacement of the oil filterLubrication Checking and adjustment of the throttle wire Replacement of the fuel filter Checking the tyre pressure Trouble Shooting Schedule Problem Procedure Winter storage ServiceStorage Wiring Diagram Technical Data Rider 1030 Bioclip, Rider English «*2h6+¬ English «*2h6+¬