Check the transmission’s air intake | Husqvarna 1200, 1030 BioClip

MAINTENANCE

Check the transmission’s air intake

Check that the transmission’s air intake in not blocked.

Check the transmission’s oil level

1.Check the transmission’s oil level by looking through the mesh on the air intake. The oil level

should lie between the MIN and MAX markings on the oil canister at 20° C.

If oil needs to be added the transmission cover must be dismantled first. Release the two screws (one on each side) and then lift off the transmission cover.

2.Screw off the oil canister cap and top up with engine oil SAE 10W/30, class CD–CF, until the oil level reaches the MAX marking. Screw the oil canister cap back on, and fit the transmission

cover.

20 – English

Image 22

Husqvarna 1200, 1030 BioClip manual Check the transmission’s air intake, Check the transmission’s oil level

Contents

Rider 1030 BioClip Rider 101 89 Svenska Contents General operation Safety InstructionsSafe operation practices for ride-on mowers II. Slope operation IV. Service Explanation of Symbols Read the instructions These instructions are for your safety. Read them carefully General use Driving on slopes Do as follows Children MaintenanceDo not do the following Never drive the machine in an enclosed space Presentation PresentationLocation of the controls Choke lever Throttle controlSpeed limiter Cutting unit Lift lever for cutting unit Seat Lever for adjustment of the cutting heightParking brake Fuelling Before starting DrivingStarting the engine Driving the machine Cutting tips MAX Stopping the engineDisengage lever Daily Maintenance interval MaintenanceMaintenance schedule Hours Front hood Dismantling of the machine hoodsEngine hood Right-hand fender Check the engine’s cooling air intake Check the engine’s oil levelChecking of the fuel pump’s air filter Check the transmission’s air intake Check the transmission’s oil level Checking and adjustment of the steering wires Check the safety system Checking and adjusting the brakeCheck the level of the battery acid Poorly adjusted brakes can result in reduced braking power Do not use compressed air to clean the paper filter Replacing the air filter Maintenance Checking and adjusting the cutting unit’s parallelism Dismantling the cutting unit Checking the blades Changing the oil Lubrication Replacement of the oil filterGeneral lubrication Checking and adjustment of the throttle wire Replacement of the fuel filter Checking the tyre pressure Trouble Shooting Schedule Problem Procedure Storage ServiceWinter storage Wiring Diagram Technical Data Rider 1030 Bioclip, Rider English «*2h6+¬ English «*2h6+¬