CARE AND MAINTENANCE
MOWER DECK LEVELING PROCEDURE:
There are a total of (4) threaded adjusters which will control the attitude or pitch of the mower deck. The adjusters have lock nuts on the bottom which can be turned up or down to raise or lower the front and rear of the mower deck. Deck should be level or pitched slightly higher in rear.
A.Place the mower on a smooth level surface, check tire pressures to insure the mower has a correct stance. Inflate tires as required:
Front: 16 - 21 lbs maximum
Rear : 8
B.Turn each outer blade tip to align with the deck or in a side to side manner.
C.Measure from the floor surface up to the bottom of the blade tip on the discharge side of the mower deck. Retain this measurement. Move to the opposite side, check that measurement is the same. If adjustment is required, turn the nut on the bottom of the front threaded adjuster up or down until both side to side measurements are equal. Retain measurement.
D.Turn both outer blades to align with the deck in front to rear manner. Turn left rear adjuster nut up or down until rear of mower deck is positioned level to 1/8th of an inch higher in the rear than the side to side measurement. At this time, the mower deck will be suspended on (3) points (both front adjusters and the left rear adjuster). Move the right rear adjuster and take out the slack which will be present by turning adjuster lock nut up.
E.Confirm measurements once again. Blade tips should be level in a side to side manner. In the rear, blade tips should be level to 1/8" higher than side to side measurement. In the front, blade tips should be level to 1/8" lower than side to side measurement.
NOTE: This will place the mower deck in a base measurement position. Additional adjustment may be required to achieve desired cut for the type of grass or conditions being mowed.
FRONT
ADJUSTERS
LEFTREAR
ADJUSTER
DECKLEVELINGADJUSTMENTPOINTS
Page 34