Dixon ZTR 5017, ZTR 5022 manual 5020, Specifications, Model ZTR

SPECIFICATIONS

		Model ZTR	5020
CHASSIS:	11 GA - rectangular tube
BODY:	Two piece - made of rotational molded polyethylene. Front body contains
	access panels for battery service and engine to mower deck belt removal. Rear
	body tilts up to allow service on the entire drive system.
SEAT:	Designed for operator comfort by use of high density closed cell foam padded
	back rest and arm rests, upholstered with CorduraTM water-repellent fabric.
	Seat is adjustable fore and aft.
MOWER DECK:	3 Decks are available. 42" &		60" are made of stamped steel. 50" is made of
	11 GA fabricated welded construction with external reinforcement ribs
	3 blades combine for either a 42", 50", or 60" cut width
	Cut height	approximately 1.5" to 4.5" via 8 position lift handle
BLADE DRIVE:	Electric clutch
DRIVE SYSTEM:	Each rear wheel is independently driven by a HydroGear BDU-10L Series 70
	hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully
	enclosed HydroGear gearbox.
ENGINE:	20HP Briggs & Stratton Intek, overhead valves, replaceable oil filter, full
	pressure lube system, dual element air cleaner, integral fuel pump.
STARTING SYSTEM:	Electric by key switch operation with safety interlocks on parking brake and
	blade drive clutch.
TIRES:	Front	11 X 4 X 5 smooth profile
	Rear	20 X 10.5 X 8 Multi Trac
RECOMMENDED	Front	16 - 21 lbs.
TIRE PRESSURE:	Rear	8 - 14 lbs.
CAPACITIES:	Fuel - 4.8 gallons total (dual tanks)
	Hydrostat oil tank - 3 quart with in-line 10 micron filter
	Hydrostat oil recommendation, refer to page 37
	Engine - 2 qts. SAE 30 (with filter)
DIMENSIONS:	Width	54"(42" Deck), 60"(50" Deck), 73"(60"Deck)
	Height	45"
	Length	72"
	Weight	630 lbs.(42" Deck), 668 lbs. (50" Deck), 685 lbs. (60" Deck)
NOTE:	Additional information provided in service instructions under the individual
	component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Page 13