6.3
This gate operator is designed with
Constant tone is heard when power is applied: This indicates that the limit switch wire harness is not connected to the circuit board. In this condition, the operator will not run and the tone will continue until the fault is corrected. Check to be sure that the limit switch plug is properly inserted into P2.
Constant tone is heard: This indicates that the operator is in a hard shutdown condition. The tone will continue to sound for five minutes, and then will beep once every five seconds. The
Short tone is heard every five seconds: This indicates that the operator has been in a hard shutdown condition in excess of five minutes. This will continue until the
Operator runs for 1 second and stops, two short tones are heard: This indicates that there may be a fault with the current sensor circuit. Check that the black current sensor wire has been passed through the hole in the current sensor donut with the correct number of loops (1/2 HP motor - 2 loops, 1 HP motor - 1 loop).
6.4 Accessory Items
The following accessory items are available for the model 6500 swing gate operator.
Contact Sensors - For use as a secondary entrapment protection device. Miller Edge, Inc., MGO20, MGR20, MGS20 Photo Cell -
MMTC, Inc. Model IR55 | P/N |
MMTC, Inc. Model | P/N |
Carlo Gavazzi Type PMP12 | P/N |
Carlo Gavazzi Type PMT | P/N |
Loop Detector - Detectors plug directly into ports on circuit board simplifying wiring. P/N
Magnetic Lock - Magnetic Gate Lock Kit provides an excellent means to secure swing gates and is a
Remote Reset - Provides a remote station to reset an operator in a hard shutdown condition. Must be mounted in
Control Station - Interior station mounts into
Interconnect Cable - Interconnect wire cable contains all the necessary wires to interconnect primary / secondary operators. Cable length 30 feet. P/N
Cable length 40 feet. P/N
Time Clock - 7 day and 365 day time clocks can be used to automatically open gate at
P/N
Torsion Rods - Torsion rod assembly is used on uphill swing gates for counter balance. P/N
Hinges -
Surge Devices - High and low voltage surge suppressors help prevent circuit board failure caused by lightning strikes and power surges.
P/NSpeed Bumps - Prefabricated
34 |