Installation
Annunciator Outputs
12.1Description
The four annunciator outputs can be programmed to indicate the activity of the panel's zones or conditions occurring on the system. Annunciator outputs do not provide a voltage but instead switch to ground voltage from another source. The outputs can respond to any of the conditions listed below:
1)Activation by zone condition: Steady, Pulse, Momentary, or Follower
2)Manually from the Security Command keypad
3)Communication failure
4)Armed area annunciation
5)Fire Alarm or Fire Trouble
7)Ambush alarm
8)Exit and Entry timers
9)System Ready
10)Ground start activation
12.2Harness wiring
The open collector outputs are accessible by installing the DMP 300 Harness on the
Output | Color | Wire |
1 | Red | 1 |
2 | Yellow | 2 |
3 | Green | 3 |
4 | Black | 4 |
Telephone RJ Connector
13.1Description
Connect the panel to the public telephone network by installing a DMP 356 RJ Cable between the panel's J4 connector and the RJ31X or RJ38X phone jack.
Phone Cable Monitor
A two pin header labeled RJ SUP (J7) is provided to allow monitoring of the telephone cable connected between the panel and a RJ38X jack (pins 2 & 7 jumpered). Attach a DMP Model 306 Harness between J7 and any available zone. The pins of J7 are connected via the telephone cable to 2 & 7 of the RJ38X jack. The RJ38X jack provides a jumper between pins 2 & 7 which completes the circuit.
When the zone is programmed for a Supervisory type (SV) and the telephone cable is removed, the keypad will display the zone in trouble and produce a steady tone.
13.2ACA Compliance
The XR6A/XR10A/XR20A have been tested and meet the requirements of ACA Technical Standard
13.3Ground start
To configure the XR6A/XR10A/XR20A for ground start operation, you must install the appropriate ground start module and program one of the panel's available annunciator outputs for Ground Start operation. Refer to the XR6A/XR10A/XR20A Programming Guide for complete programming information.
XR6A/XR10A/XR20A Installation Guide
Digital Monitoring Products | 2841 E. Industrial Drive Springfield, MO USA |
Page 12