DMP Electronics XR10A, XR6A Introduction, Panel Specifications, 1.1Power supply, 1.2Communication

Introduction

Panel Specifications

1.1Power supply

Transformer Input: 16.5 VAC 40VA or 16.5 VAC 20VA

Standby Battery: 12 VDC 7.0Ah (40VA transformer charges up to 2 batteries)

Auxiliary Output: 12 VDC at 500mA

Bell Output: 12 VDC at 1.5 Amps with 40VA transformer, 600mA with 20VA transformer

Smoke Detector Output: 12 VDC at 100mA All circuits inherent power limited

1.2Communication

Built-in SDLC Digital Dialer communication to DMP Model SCS-1 Receivers Built-in 4-2 communication to non-DMP receivers

Built-in M2E (Radionics Modem IIe) communication to non-DMP receivers (XR20A only) Built-in CID (Contact ID) communication to non-DMP receivers

All panels can operate as a local system.

1.3Panel zones

Nine 1k W EOL burglary zones (zones 1 to 9), (zones 1 to 5 on XR6A)

One 3.3k W EOL Class B powered fire zone with reset capability (zone 10 on XR10A and XR20A), (zone 6 on XR6A)

1.4Keypads

You can connect up to four of the following supervised keypads to the XR6A/XR10A/XR20A panels.

•16 or 32 character alphanumeric keypads

•10-zone LED keypads

In addition, four and single point zone expanders can be added to the XR20A panel.

When using the FA426 Wireless Receiver, the XR20A allows unsupervised devices to be added to address five.

1.5Outputs

The XR6A/XR10A/XR20A panels provide four open collector outputs rated for 50mA each. See section 12.1. A Model 300 Wire Harness is required. The open collector outputs provide the ground connection for a positive voltage source.

1.6Enclosure specifications

The XR6A/XR10A/XR20A panel ships in an enclosure with EOL resistors, battery leads, user's guide, and programming sheet.

Size:	12.5" W x 9.5" H x 2.75" D
Weight:	4 lbs
Color:	Gray or Black
Construction:	20 gauge cold rolled steel

XR6A/XR10A/XR20A Installation Guide

2841 E. Industrial Drive Springfield, MO USA 65802-6310 800-641-4282 Digital Monitoring Products

Page 1