DMP Electronics XR10 All/Perimeter System Arming, System Ready/System Not Ready Keypad Displays

All/Perimeter System Arming

Area Assignment: Your security system is divided into two separate areas. Motion detectors, inside doors, and other interior protection devices are assigned to the Interior area while windows and exterior doors are assigned to the Perimeter area.

Perimeter or All: When arming an All/Perimeter system, the keypad

displays PERIM ALL. If you select ALL, you arm both the Perimeter and the Interior of the system. You’ll want to arm both of these areas when leaving with nobody left inside. Selecting PERIM arms only the Perimeter of the system. Perimeter arming is for when you’re staying inside but want the comfort of knowing the exterior doors and windows are armed. Perimeter arming allows you to move freely about inside without setting off any interior alarms.

System Ready/System Not Ready Keypad Displays

When all zones in the system are in a normal condition, the keypad displays SYSTEM READY. If there are one or more zones that are not in a normal condition, the keypad displays SYSTEM NOT READY. Pressing any top row SELECT key during this display shows the zone name allowing you to investigate the problem.

Bypass and Force arming

When one or more zones are in a non-normalcondition, the keypad displays OKAY BYPASS STOP. Select OKAY to force arm the bad zones. Force armed zones that restore to normal while the system is armed are included back into the system. Select BYPASS to bypass the bad zones. Bypassed zones that restore to normal while the system is armed are NOT included back into the system. Use the bypass feature to remove a zone from the system that is temporarily out of service. This is a useful feature during remodeling when doors or windows are being removed.

Arming an All/Perimeter System

1. Enter your user code. The keypad displays PERIM ALL.

2.Select PERIM to arm the Perimeter area only.

3.Select ALL to arm both the Perimeter and Interior areas.

4.The keypad displays any zones that have been bypassed prior to arming and 24 hour zones that are in a bad condition.

5.Bypass or force arm any bad zones if required. See below:

5a. If a problem exists on a zone, the zone name and problem is displayed followed by OKAY BYPASS STOP.

5b. Select OKAY to force arm the bad zone.

5c. Select YES to bypass the bad zone.

5d. Select STOP to stop the arming. Correct the problem on the zone and return to step 1.

6.The Security Command displays PERIMETER ON if only the perimeter is being armed and ALL SYSTEM ON if both the perimeter and interior are being armed.

7.The Security Command next displays EXIT: ## INSTNT and begins to count down the number of seconds remaining for you to exit. When the delay expires, all zones are armed.

8.You can select INSTNT while EXIT: ## INSTNT is displayed to immediately arm all exit zones and make them instant zones without exit or entry delays. The keypad displays INSTANT.

9.When the system is fully armed, the keypad displays PERIMETER ON for perimeter arming and ALL SYSTEM ON for perimeter and interior arming.

Arming and Disarming 7