All/Perimeter System Disarming
Disarming: While the system is armed, you can only enter the premises through an entry/exit delay door without causing an alarm. After opening the door, the Security Command keypad sounds a prewarn tone to remind you to disarm the system. You must disarm the system before the prewarn tone expires or an alarm on the door zone will occur.
During the prewarn tone, the keypad displays ENTER CODE:. Enter your security code to disarm the system.
Alarm Display: After disarming, the keypad displays any zones that tripped or any transmission problems that occurred during the armed period. All burglary zones are then disarmed and any bypassed zones are automatically reset.
Disarmed Message: The keypad displays ALL SYSTEM OFF after the system disarms.
Central Station Report: A report of the system disarming can be transmitted to the central station. This is optional and can be programmed for you at any time.
Disarming an All/Perimeter System
1.During the entry delay time, the keypad displays ENTER CODE:
. Enter your security code number.
2.The keypad then displays any zones that went into alarm or any communication problems that occurred during the armed period.
3.The keypad next displays ALL SYSTEM OFF to confirm the system is disarmed.
Disarming During an Alarm
1. While the alarm bell or siren is sounding, enter your security code number. The keypad displays DISARM SILENCE.
2.Press the SELECT key under DISARM to disarm the system and silence the alarm.
The keypad next displays ALL SYSTEM OFF to confirm the system is disarmed.
3.Press the SELECT key under SILENCE to stop the bell or siren but NOT disarm the system. Selecting SILENCE sends a Bell Silenced report to the central station.
4.If your system is programmed to send an Abort (alarm cancel) report to the central station, the keypad displays ALARM CANCELLED.
If you do not press any SELECT key while DISARM SILENCE is displayed, the system automatically selects DISARM and disarms the system.
8 | Arming and Disarming |
