Outputs On Off
User Code Level: Master or Standard.
Function: Allows you to turn the system's outputs on and off.
This function is used to individually turn your system’s relay outputs on and off. Your system may use these outputs to control interior and exterior lighting, or heating, air conditioning, or other appliances.
The names and numbers of the outputs on your system are located in the System Setup section at the back of this guide.
Turning the Outputs On and Off
1.Access the User Menu.
2.Press the COMMAND key until OUTPUTS ON/OFF? displays.
3.Press any one of the SELECT keys.
4.The keypad displays OUTPUT: - ON OFF.
5.Enter the output number you want to turn on or off. The output number will appear in the display.
6.With the output number displayed, press the SELECT key under ON or OFF. The output is then turned on or off, depending on your selection, and remains in that state until you change it.
7.The system automatically removes the output number and a new output number can be entered. Refer back to step 5.
To exit the Output menu option, press the ARROW key until you've returned to the keypad's Status List.
Bypass Zones
User Code Level: Master or Standard.
Function: Allows you to bypass a zone prior to arming the system.
Bypassing is usually done when a zone cannot be restored to normal and you want to arm the system. Once bypassed, the system will not respond to any activity on the zone.
A zone can be bypassed only while it's disarmed. Since Fire, Panic, Emergency, and Supervisory zones are always armed, they can never be bypassed.
The Bypass Zones function can also be used to restore a bypassed zone back into the system. This can only be done while the zone is disarmed.
When Bypass Zones is selected, a report of the bypassing can be sent to your central station. This is optional and can be programmed for you at any time.
Using the Bypass Zones Function
1.Access the User Menu.
2.Press the COMMAND key until BYPASS ZONES? displays.
3.Press any one of the SELECT keys. The keypad displays ZONE: - RST BYPS.
4.To reset a zone, enter the zone number and press the SELECT key under RST.
5.To Bypass a zone, enter the zone number and press the SELECT key under BYPS.
12 | User Menu |
