Model DP569 User’s Manual DolbyRemote
5-3
DolbyRemote ships with a cable for RS-232 connection between a PC and the front-
panel of a DP569 encoder. Additional cables may be purchased from Dolby Laboratories.
RS-485 connection for the DP569 requires a separate cable, not provided. This
connects to the rear panel serial port of the unit. Consult Section 6.2.6 for RS-485
support information.
5.2.4 DP569 Setup
To operate using DolbyRemote it is necessary to place the DP569 into remote mode.
Press Shift, ←to access remote mode.
5.3 Starting DolbyRemote
From the Windows Start button, select DolbyRemote from the folder in which you
installed the DolbyRemote application. The Open Device window is displayed,
Figure 5-1.
Figure 5-1 DolbyRemote Open Device Window
5.3.1 Device Type
Select the Dolby encoder model to be controlled. The application will also control older
Dolby encoders (i.e., the DP561 and DP567).
5.3.2 Communications
Port
Select the computer communications port to be used. DolbyRemote allows COM1
through COM10. The correct port will depend on the computer configuration.