Installing the Regulator
Follow the instruction manual included with the alternator/regulator. Here are a few additional tips.
Mount the regulator inside the truck (Fig. 7), in an accessible area, so that the LED display can be seen.
The wiring harness has two main separate harnesses. One goes to the battery box and one to the alternator. Follow the wiring directions included.
Only one of the wires marked “Ignition” will be used. Use whichever lead is most convenient.
The two wires with blue
Secure the relay and fuse holders using a mounting screw or a cable tie.
A connection wire is required from the
Route and clip wires safely to prevent chafing.
•If your existing alternator has a “Sense” wire attached, you will need to add a relay to make the “Alternator” or “Charge” dash light work correctly. See drawing “Charge Light Circuit for Alternators” below. The relay required is a small
10
Figure 7 – Regulator mounted inside truck
ENGLISH