DM 2610013190 06-11:DM 2610013190 06-11.qxp 6/6/11 10:43 AM Page 12

"LOCK-ON" BUTTON

The "Lock-ON" feature, incorporated into the paddle switch, is a convenience for long operations.

TO LOCK SWITCH "ON": After paddle switch has been activated push "Lock-ON" button at rear of tool completely in and release paddle switch (Fig. 4).

TO SWITCH TOOL "OFF": Squeeze and release paddle switch (Fig. 4).

In order to try to avoid recoil (a situation where the wheel wants to skip out of the material) it is recommended to make cuts in the same direction as the rotation of the wheel.

It is important to read and ! WARNING understand the section in

this manual called “Kickback and Related Warnings”.

FIG. 4

"LOCK-ON"

BUTTON

"LOCK-OFF" SWITCH

RELEASE LEVER

PADDLE SWITCH

DEPTH ADJUSTMENT

Disconnect plug from power source. Loosen the depth adjustment lever located on the right side of the tool. The foot is spring loaded and will lower automatically (Fig. 5).

Tighten lever counter clockwise at the depth setting desired. Check desired depth (Fig. 5).

DEPTH

ADJUSTMENT

LEVER

FIG. 5

DEPTH SCALE

LINE GUIDE

LINE GUIDE

FIG. 6

The cutting guide notch will give an

 

 

approximate line of cut (Fig. 6). Make sample

 

 

cuts in scrap lumber to verify actual line of cut.

 

 

-12-

Page 12
Image 12
Dremel SM20 manual LOCK-ON Button, Depth Adjustment Lever Depth Scale Line Guide