Drive Medical Design PhoenixHD4, PhoenixHD3 owner manual How to adjust the seat height

4 . OPERATION

& Suggestion

1.You should recharge the batteries after each time the vehicle is used to ensure maximum range. The batteries should be charged up at least once a week even if the scooter is not used.

2.After charging or replacing a new battery, drive the vehicle for 2-3 minutes to make sure the battery capacity is sufficient.

3.In wintertime, the battery may respond more slowly and the battery range may be reduced.

4.When driving on a gradient, the battery indicator light might move up and down. This is a normal phenomenon so please do not worry.

5.Even if the battery is used properly, it is natural for the battery’s capacity to reduce with time, which results in reduced battery range compared to a brand new battery. Therefore, when you find the battery’s range is about only 50% of the range when the batteries were new, it is time to replace the batteries. Please see your dealer about replacement batteries. If you continue to use the old battery when it should be replaced, it could lead to a rapid decline in performance.

6.The battery range will be reduced when driving frequently on a slope or rough terrain, as this leads to greater consumption of power.

7.The batteries have a six-month warranty covering manufacturing defects. This warranty does not cover faults due to incorrect battery recharging.

■ How to adjust the seat height

1.Remove the seat from your scooter.

2.Remove the pin lock from the lower seat post.

3. Adjust the upper seat post to the desired seat height.

4.Move the upper seat post so that there is a hole to insert the locking pin.

5.Insert the pin lock and replace seat replace seat.

Pin lock

12