NORMAL OPERATION
Using the Rotisserie
WARNINGS:
Read all instructions before using your rotisserie. This rotisserie is for outdoor use only.
Remove motor and store in a dry place when not in use. Do not touch hot surfaces. Use barbecue mitts.
This rotisserie is not for use by children.
To protect against electrical hazards do not immerse cord, plugs, or motor in water or other liquids.
Unplug the motor from outlet when not in use or before cleaning.
Do not use rotisserie for other than intended use. Make sure motor is OFF before placing it on the motor bracket.
Do not operate the rotisserie motor with a damaged cord or plug.
Do not operate the rotisserie motor if it should malfunction. The rotisserie motor is equipped with a three prong (ground- ing) power cord for your protection against shock hazard.
The power cord should be plugged directly into a properly grounded three prong receptacle. If use of an extension cord is required, be sure that it is a minimum 16 AWG, 3 wire well insulated cord, marked for outdoor use only and properly grounded.
When using an extension cord, make sure it is not in contact with a hot or sharp surface.
Outdoor extension cords should be marked with the letters
Do not cut or remove the grounding prong from the rotis- serie motor power cord.
Do not let cord hang over any sharp edge or hot surface. Do not expose to rain.
To reduce the risk of electric shock, keep extension cord connection dry and off the ground.
A short power cord is supplied to reduce the risk of tripping over the cord. Extension cords may be used, but caution must be taken to prevent tripping over the cord.
In absence of local codes the rotisserie motor must be grounded electrically in accordance with the National Elec- trical Code, ANSI/NFPA 70, or Canadian Electrical Code, CSA C22.1.
WARNING: Setup the rotisserie with food before lighting
Rotisserie Burner. Operating the Rotisserie
1.Remove rotisserie shaft from grill.
2.Loosen and remove right side bearing, the counterbalance and right side spit fork.
3.Push the rotisserie shaft through the center of the food.
4.Slide the right side spit fork back onto the shaft. Insert the tines of both spit forks into the food. The food should be centered on the shaft. Tighten spit fork thumb screws.
5.Place left side bearing (welded in place) groove into the left side spit rod mount
6.Place the right side bearing onto the spit rod and insert the pointed end of the spit rod into the rotisserie motor.
7.Line up both the groove on the right side bearing with the right side spit rod mount
8.The rotisserie shaft should rotate so that the heavy side of the meat or poultry ro- tates down to the bottom. Large cuts of meat may require the removal of the cook grates to allow full rotation of the spit rod. Note: Remount the food and/or use the counterbalance if necessary for better balance on the spit rod. The counterbal- ance can be mounted after Step 5 above.
9.Plug the motor in and turn it on.
10.Follow Lighting Instructions. The cord can be routed through the access hole at the back of the grill Plug cord into the accessory outlet inside the base cabinet.
CAUTION: Do not use more than 9.5A from the receptacle.
17
